Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
- Gear shifting box
- 5-staged manual box of gear shifting
General information
Replacement of epiploons of power shafts
Check of a state and replacement of a support of the transmission
Removal and installation of draft of the drive of gear shifting
Check and replacement of the sensor switch of fires of a backing
Removal and RKPP installation
Capital repairs of RKPP - the general information
+ 4-staged and stepless automatic transmissions (ат and cvt)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of draft of the drive of gear shifting
Gear shifting drive components
|
|
|
|
1. Components of the drive of gear shifting are given on a covering note an illustration above. Turn off and remove the gear shifting lever handle. Remove the central console (see the Head Kuzov). Remove the top dustproof cover of the lever and the lower boot (see an accompanying illustration). |
2. The car also establish to Poddomkratta it on props.
|
|
3. For a detachment of a jet bar of the lever of switching from RKPP case simply turn out a fixing bolt (see an accompanying illustration). |
|
|
4. For a switching drive lever detachment to transmission wring out a dustproof cover forward, remove a collar and a drift beat out a spring pin (see an accompanying illustration). |
|
|
At assembly the spring pin is subject to replacement without fail. |
|
|
5. For a detachment of the back end of draft of the drive from the lever of switching give fixing a bolt with a nut (see an accompanying illustration). |
6. Give two nuts of fastening of the holder of a spherical support of the lever to the lower part of an arm of a jet bar (see the previous illustration), throw off washers, then remove the holder, the lower boot of the lever, a saddle of a spherical support and the lever of switching with a jet bar.
7. Check a condition of the rubber plug of a support of fastening of the forward end of a jet bar of the lever, in case of identification of cracks, gaps or signs of wear make replacement.
8. Replace sealing rings of assembly of fixture of the lever of switching.
9. Assembly is made upside-down. Before installation grease sealing rings and rubber plugs with silicone lubricant. Do not forget to replace a spring pin of fastening of thirst of the drive of switching for the transmission. Tighten all fixture with the required effort.
10. Check serviceability of functioning of the lever of gear shifting. |
|
|
|