The device, service, repair of Honda Civic and Acura Integra - the Five-step manual box of gear shifting//since 1994 release / civic2.ru

Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
- Maintenance instruction
   Arrangement and functions of governing bodies
   Keys and locks
   Adjustment of seats
   The equipment and governing bodies in salon
   Heater and air conditioner
   Control system of a microclimate of salon
   Audio system
   Security systems
   Running in of the new car
   Unlocking of a cowl
   The valve of shutdown of supply of fuel in case of accident (on some models)
   Start of the engine
   Five-step manual box of gear shifting
   Automatic transmission
   Stepless variator (separate models)
   Devices of external lighting and alarm systems of the trailer
   Check of level of liquid in automatic transmission
   Driving belts
   Emergency closing of the panel of the hatch of a roof
   Safety locks
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


http://flashlottos24.ru/



Five-step manual box of gear shifting

For ensuring smooth and unaccented switching all transfers of the forward course are synchronized. On the transmission there is a blocking device which excludes a possibility of direct switching from the fifth transfer to transfer of a backing. When switchings the transmission "up" (on the highest steps) or "down" (on the lowest steps) completely switch off coupling. After transfer of the lever of switching of the transmission to the provision of the following transfer smoothly release a coupling switching off pedal. During the movement on any transfer you do not hold a leg on a coupling pedal. It can result in bystry wear of details of coupling.

Include transfer of a backing only after a full stop of the car. The attempt to include transfer of a backing on the moving car can become the reason of breakage of transmission. Completely switch off coupling and make a short pause in several seconds before including transfer of a backing. Instead of keeping of a short pause it is possible to switch on and off one of transfers of the forward course and then at once to transfer the lever to the provision of transfer of a backing. The described methods of inclusion of a backing allow to prevent shock inclusion of transfer because of residual rotation of gear wheels.

For delay of the car you can use braking by the engine, having switched the transmission to one of the lowered steps. Braking by the engine allows to control car speed at the safe level and prevents an overheat of brake mechanisms at the movement on long descents with a considerable bias. Switch the transmission to the lowered steps consistently, in process of reduction of speed not to allow excess of the most admissible frequency of rotation of a bent shaft of the engine. After inclusion of a low gear control the frequency of rotation of a shaft of the engine on a tachometer (if it is available on the car). The arrow of a tachometer should not come into a red zone of a scale. In all cases it is necessary to be guided by the values of the maximum speed of the car on various transfers given in Specifications.

At movement along the road with a slippery covering sharp delay or dispersal can lead to loss of control over the car and accidents as a result of which you risk to be traumatized. Be especially careful if a condition of a paving such is that does not provide reliable coupling with car wheels.