Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
- Cooling system and heating
   Specifications
   Antifreeze - general information
   Check of serviceability of functioning and replacement of the thermostat
   Check of a condition of the fan(s) of the cooling system and chain of its inclusion, replacement of the fan(s)
   Removal and installation of a radiator and broad tank of the cooling system
   Removal and installation of the oil cooler
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of the measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of an electric motor of the drive of the fan of a heater
   Removal and installation of assembly of the control panel of functioning of a heater and conditioner of air, adjustment of a driving cable
   Replacement of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of a clutch coupling of the K/V compressor
   Removal and installation of a receiver dehumidifier To/in
   Removal and installation of the K/V compressor
   Removal and installation of the K/V condenser
   Removal and installation of the K/V evaporator with the broad valve
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, replacement of components

Check

 PERFORMANCE ORDER

1. Check a condition of safety locks and all terminal connections of the corresponding electric chain. Make sure of completeness of a charge of the battery.
2. Transfer transmission to situation "P", cock the parking brake and turn the ignition key in position of ON, without starting the engine.

3. Without disconnecting a heater fan electric motor, connect a wire crossing point to the plug of a blue-black wire from a reverse side of the socket of the motor (see an accompanying illustration), ground the opposite end of a wire on weight. If the motor starts working, therefore the cause of failure lies in malfunction of the switch, resistors or a connecting electrical wiring.

4. If the motor does not function at the grounded plug of a blue-black wire, remove a wire crossing point, disunite the socket and by means of the voltmeter measure tension between the plug of a blue-black wire and weight (see an illustration above). On all models if the voltmeter fixes battery tension, and the motor does not function, in one of the high-speed modes, make its replacement (see Removal and installation of an electric motor of the drive of the fan of a heater). If tension is absent, check a condition of the relay of the motor and a connecting electrical wiring (see the Head Onboard electric equipment).

5. Resistor assembly is located on a casing of a driving electric motor of the fan (see an accompanying illustration). On a payment several resistors which provide a possibility of the choice of the low and average high-speed modes of functioning of the fan are installed to assembly.

6. If the motor rotates, however there is no possibility of the choice of one of the high-speed modes, remove resistor assembly from a casing of a heater and visually check it for existence of damages. by means of an ohmmeter check resistance between plugs 2 and 4 (see an accompanying illustration). If resistance any of resistors is shown below norm, or is equal to infinity, replace assembly.

Replacement

 PERFORMANCE ORDER

1. Turn out two fixing screws and remove a payment of resistor assembly from a heater casing.
2. Installation is made upside-down.