Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
- Cooling system and heating
   Specifications
   Antifreeze - general information
   Check of serviceability of functioning and replacement of the thermostat
   Check of a condition of the fan(s) of the cooling system and chain of its inclusion, replacement of the fan(s)
   Removal and installation of a radiator and broad tank of the cooling system
   Removal and installation of the oil cooler
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of the measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of an electric motor of the drive of the fan of a heater
   Removal and installation of assembly of the control panel of functioning of a heater and conditioner of air, adjustment of a driving cable
   Replacement of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of a clutch coupling of the K/V compressor
   Removal and installation of a receiver dehumidifier To/in
   Removal and installation of the K/V compressor
   Removal and installation of the K/V condenser
   Removal and installation of the K/V evaporator with the broad valve
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


http://flashlottos24.ru/



Check of an electric chain of a clutch coupling of the K/V compressor

1a. At refusal of inclusion of coupling of the compressor first of all it is necessary to remove the corresponding relay and to check its state (see accompanying illustrations). Arrangement of plugs of the relay (Civic model).

1b. An arrangement of plugs of the relay (the Integra model for 1997 the issue).

1 pages. An arrangement of plugs of the relay (the Integra model since 1998 of the issue).


2. If the relay as it should be, make sure available tension between plugs of its reception nest and weight, having checked thereby serviceability of giving of food to the relay. If tension is absent, therefore, the break in a chain which should be found and eliminated takes place.
3. Having made sure of serviceability of giving of food to the relay, establish a wire crossing point between plugs 1 and 3 (Civic model), And yes With (the Integra models till 1997 to the issue) or 1 and 2 (Integra since 1998 of the issue) relay nests – the distinct click demonstrating operation of a clutch coupling of the compressor has to sound.

4. If the coupling does not work (there is no click), remove a wire crossing point, disconnect an electrical wiring from the coupling and check existence of conductivity between a red wire of its socket and the compressor (see an accompanying illustration). In case of need eliminate break. With conductivity check serviceability of a condition of the coupling.

5. Disconnect the sensor switch of pressure of a low pressure To/in and, at the included ignition, make sure available battery tension between the plug 1 (Civic – the plug of a blue-white wire), or 2 (Integra – the plug of a blue-red wire) and weight. Lack of tension testifies break existence. Otherwise switch off ignition and make sure available conductivity between plugs of the sensor switch. If conductivity is absent, check the sensor switch and pressure in system.