Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car

Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Check of a state and replacement of the battery
   Check of a state and replacement of wires of the battery
   System of ignition - the general information
   Check of functioning of system of ignition
   Check of a state and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management of ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation and adjustment of a corner of an advancing of ignition
   System of a charge - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and installation of the generator
   Replacement of the regulator of tension and brushes of the generator
   System of start - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and installation of a starter
   Removal and installation of the traction relay
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Specifications

System of ignition

Ignition coil

Characteristic	Value
Civic (Hitachi distributor)
Resistance of primary winding, Ohm	0.45÷0.55
Resistance of a secondary winding, kOhm	22.4÷33.6
Civic (TES distributor)
Resistance of primary winding, Ohm	0.63÷0.77
Resistance of a secondary winding, kOhm	12.8÷19.2
Integra
Resistance of primary winding, Ohm	0.6÷0.8
Resistance of a secondary winding, kOhm	12.8÷19.2

Installation of a corner of an advancing of ignition

Characteristic	Value
Civic
Models with RKPP D16Y5, D16Y8	12 ° ± 2 ° before VMT (Krasn.) at 450 ± 50 rpm
D16Y7
USA	12 ° ± 2 ° before VMT (Krasn.) at 670 ± 50 rpm
Canada	12 ° ± 2 ° before VMT (Krasn.) at 750 ± 50 rpm
Models with AT/CVT
USA	12 ° ± 2 ° before VMT (Krasn.) at 700 ± 50 rpm
Canada	12 ° ± 2 ° before VMT (Krasn.) at 750 ± 50 rpm
Integra
B18B1, B18C1	16 ° ± 2 ° (Krasn.) at 750 ± 50 rpm
B18C5	16 ° ± 2 ° (Krasn.) at 800 ± 50 rpm

System of a charge

Characteristic	Value
Minimum admissible length of brushes of the generator, mm	1.6