Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
- Engine
   + Repair of the engine without extraction from the car - the Civic model
   - Repair of the engine without extraction from the car - the Integra model
      General information
      Preparatory actions and the list of repair procedures which can be executed without extraction of the engine from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP)
      Removal and installation of a cover of a head of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal, check of a state and installation of a gas-distributing belt and cogwheels of the GRM drive
      Replacement of a forward epiploon of a bent shaft
      The VTEC systems - the general information and check of a condition of components
      Removal, check of a state and installation of camshafts and assembly of yokes
      Replacement of valvate springs with plates and maslootrazhatelny caps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a state and installation of the oil pump
      Replacement of a flywheel / driving disk
      Replacement of a back epiploon of a bent shaft
      Check of a state and replacement of support of a suspension bracket of the power unit
   + General and capital repairs of the engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


http://flashlottos24.ru/


Check of a state and replacement of support of a suspension bracket of the power unit

Support of a suspension bracket of the power unit extremely seldom need attention, however the damaged pillows have to be replaced without any delay in order to avoid increase of loadings and premature wear of components of the transmission line.

Check

 PERFORMANCE ORDER

1. For check it is necessary to raise slightly the engine, having unloaded support.
2. The car also establish to Poddomkratta it on props. Get a jack under the engine case pallet (for the purpose of distribution of loading lay wooden whetstone between a head of a jack and the pallet). Cock a jack, having slightly raised the engine and having unloaded support.

Do not perform any works under the car, the lifted situation withheld in by means of only one jack at all!


3. Check pillows of support for existence of cracks, signs of hardening of rubber and separation from the metal basis. Sometimes pillows begin to break right in the middle.
4. Estimate side play size between components of support and the power unit / frame of the car (as the lever use mount or the big screw-driver). In case of identification of a side play lower the unit and tighten fixture of support.
5. Pillows in order to avoid destruction of rubber have to be processed by special protective structure.

Replacement

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery. The car also establish to Poddomkratta it on props. Prop up the engine (see paragraph 2 above).

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!


2. Release fixture, raise the engine a jack and remove a support, having separated it from an arm of a frame and the engine.

3a. Replace a pillow. Track correctness of landing of assembly in an arm Screw fixture and strongly tighten it (see accompanying illustrations): verkhy support of the engine.

3b. Right side support of the transmission.

3c. Right forward support of the transmission.

3d. Back support of the engine.

3e. The right pereny support (on a back partition of a motive compartment).