The device, service, repair of Honda Civic and Acura Integra - Removal of air from a hydraulic path of system of strengthening of a wheel//since 1994 release / civic2.ru

Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of assembly of the forward shock-absorber with a screw spring
   Replacement of the shock-absorber or screw spring of rack-mount assembly of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross stability with basic plugs
   Removal and installation of the top control lever of a forward suspension bracket
   Removal and installation of the lower control lever of a forward suspension bracket
   Removal and installation of a rotary fist and stupichny assembly
   Removal and installation of assembly of a forward nave with the wheel bearing
   Replacement of spherical support
   Removal and installation of assembly of the back shock-absorber with a screw spring
   Removal and installation of a bar of the back stabilizer of cross stability with basic plugs
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of levers of a back suspension bracket
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Removal of air from a hydraulic path of system of strengthening of a wheel
   Wheels and tires - the general information
   Angles of installation of wheels
+ Body
+ Onboard electric equipment


http://flashlottos24.ru/



Removal of air from a hydraulic path of system of strengthening of a wheel

 PERFORMANCE ORDER

1. After implementation of any procedures connected with a detachment of lines of the hydraulic booster it is necessary to remove air from a hydraulic path of PAS. Otherwise efficiency of functioning of the steering amplifier in considerably measure will decrease.
2. Develop forward wheels of the car in rectilinear situation and check level in the PAS system tank. (See the Head Routine maintenance). In case of need make the corresponding adjustment (level of liquid has to reach the lower point in a tank wall).
3. Start the engine and leave its working at turns of bystry idling. Double-check liquid level in the PAS tank. In case of need again make adjustment.
4. Rotation of a steering wheel here and there (without blows in the ends of the course) give air from system (you watch that liquid level in the tank during pumping did not fall below an admissible limit).
5. Having finished pumping, return wheels to rectilinear situation and let's the engine work within several more minutes, then muffle it.
6. Make trial runs of the car, checking serviceability and noiselessness of functioning of steering system.
7. Double-check the level of hydraulic liquid at the engine which is warmed up up to the normal working temperature (this time it has to reach mark NOTES in a tank wall). In case of need make necessary adjustment (see the Head Routine maintenance).