Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   General information and precautionary measures
   Search of causes of failures of electric equipment
   Safety locks - the general information
   Chain breakers
   The relay - the general information and check of serviceability of functioning
   Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
   Check of serviceability of functioning and replacement of understeering switches
   Check of serviceability of functioning and replacement of the switch of ignition and lock of blocking of a steering column
   Check of serviceability of functioning and replacement of switches of the dashboard
   Check of serviceability of functioning of measuring instruments of a combination of devices
   Removal and installation of a combination of devices
   Removal and installation of the radio receiver and loudspeakers
   Removal and installation of the antenna of the radio receiver
   Replacement of lamps of head headlights
   Adjustment of the direction of optical axes of head headlights
   Replacement of block headlights
   Replacement of lamps
   Running fires of daylight (DRL)
   Check of serviceability of functioning and replacement of an electric motor of the drive of screen wipers
   Check of serviceability of functioning and replacement of a horn of a horn
   Check of serviceability of functioning and recovery repair of a heater of back glass
   Control system of speed (темпостат) - general information and check of serviceability of functioning
   The electric drive of window regulators - general information and check of serviceability of functioning
   The uniform lock - general information and check of serviceability of functioning
   The electric drive of external rear-view mirrors - general information and check of serviceability of functioning
   Safety cushions - the general information
   + Schemes of electric connections - the general information




The uniform lock – general information and check of serviceability of functioning

The device consists of switches of management, door activators, the control unit and a connecting electrical wiring. Failure diagnostics of the lock is limited to checks of a condition of contact connections of an electric chain and serviceability of operation of door activators. As in system ис

пользован the electronic control unit, full diagnostics of its refusals can be made only with use of the special equipment in the conditions of a workshop of car service. The control unit of the uniform lock is located under the dashboard, to the right of the assembly block of safety locks.

Functioning of the uniform lock happens due to operation of the bidirectional electromagnets located in the doorway of the car. The switch of management has two provisions: It is LOCKED and is OPENED. At activation the switch sends a grounding signal to the control unit of door locks therefore there is the corresponding switching of activators. Depending on a starting position of the switch at its switching the control unit just changes polarity of the current given on electromagnets.
Some models can be equipped with the anticreeping system included in structure of the uniform lock of the car. If it is not possible to find a system cause of failure during conducting the listed below checks, drive away the car for fuller diagnostics on car repair shop.

 PERFORMANCE ORDER

1. First of all always check a condition of protection of a contour. Remember that on some models the chain of the uniform lock is protected by a combination of breakers and safety locks.
2. Popereklyuchayte switches of management in both directions at the killed engine. Listen to the clicks accompanying operation of electromagnets.

3. Check conductivity of switches in both of them provisions (see an accompanying illustration and the table below). Defective switches are subject to replacement.

4. Check conductivity of an electrical wiring on the site of a chain between switches, the control unit and electromagnets of activators. Execute repair of the damaged conducting.
5. Check serviceability of grounding of switches and the control unit.

6. At refusal of only one of activators remove the panel of an internal upholstery from the corresponding door (see the Head Kuzov) and check serviceability of giving of tension for an executive electromagnet, switching the switch of management. One of wires has to be powered in one of provisions of the switch, the second – in another (see an accompanying illustration).

7. At correct giving of tension replace an electromagnet.
8. If tension does not move on the activator, check the respective site of a chain (between the activator and the control unit) for existence of breaks and short circuit.

Most often damage of an electrical wiring happens on sites of a plait between a door and a body of the car and is a consequence of the dynamic loadings enclosed to a plait when opening and closing a door.

Card of conditions of the switch of control of the uniform lock

POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

IT IS LOCKED

1 and 2

OPENLY

2 and 3