Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
- Engine
   + Repair of the engine without extraction from the car - the Civic model
   + Repair of the engine without extraction from the car - the Integra model
   - General and capital repairs of the engine
      General information
      Check of pressure of oil
      Check of compression pressure in cylinders
      Diagnostics of a condition of the engine with use of the vacuum gage
      Removal from the car of the power unit - preparation and precautionary measures
      Removal and installation of the engine
      Alternative versions of schemes of recovery repair of the engine
      Order of dismantling of the engine by preparation it to capital repairs
      Dismantling of a head of cylinders
      Cleaning and check of a condition of a head of cylinders
      Service of valves
      Assembly of a head of cylinders
      Removal of conrod and piston assemblies
      Removal of a bent shaft
      Cleaning of the block of the engine
      Check of a condition of the block of the engine
      Honingovaniye of mirrors of cylinders
      Check of a condition of components of conrod and piston group
      Check of a condition of a bent shaft
      Check of a state and selection of inserts of radical and conrod bearings of a bent shaft
      Engine assembly order
      Installation of piston rings
      Installation of a bent shaft and check of working gaps of radical bearings
      Replacement of a back epiploon of a bent shaft
      Installation of conrod and piston assemblies and check of size of working gaps in conrod bearings of a bent shaft
      Trial start and running in of the engine after capital repairs
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Engine assembly order

Before starting assembly of the engine, make sure available all necessary details, materials and tools to which number the following belongs:

   a) Standard set of the metalwork tool;
   b) A dynamometer key with the drive on 1/2-dyuymv;
   c) The tool for putting on of piston rings;
   d) The tool for a staving of piston rings;
   e) Short pieces of a fuel hose for putting on on hairpins of covers of conrod bearings;
   f) Measuring Plastigage set;
   g) Set of probes of lezviyny type;
   h) A file with small tooth;
   i) Fresh motive oil;
   j) Assembly motive or lubricant on the basis of a molybdenum disulphate;
   k) Pro-masonry sealant;
   l) Sealant for fixing of threaded connections.

For saving of time and minimization of volume of the arising problems you make assembly of the engine in the following order:

 PERFORMANCE ORDER

a) Conrod and piston assemblies (B18C1, B18C5, D16Y5, D16Y7 and D16Y8 engines);
b) Bent shaft and radical bearings;
c) A back epiploon of a bent shaft with the holder;
d) Conrod and piston assemblies (B18B1 engine);
e) Maslootrazhatel of the case pallet;
f) The oil pump with a maslozabornik;
g) Case pallet;
h) Head of cylinders;
i) Camshaft(s) and assembly of yokes;
j) Water pump;
k) A gas-distributing belt with GRM drive cogwheels;
l) Inlet pipeline and final collector;
m) Sections of a forward cover;
n) Cover of a head of cylinders;
o) Flywheel / driving disk.